You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
63 lines
1.9 KiB
63 lines
1.9 KiB
#
|
|
# Multiplexer I2C chip drivers configuration
|
|
#
|
|
|
|
menu "Multiplexer I2C Chip support"
|
|
depends on I2C_MUX
|
|
|
|
config I2C_ARB_GPIO_CHALLENGE
|
|
tristate "GPIO-based I2C arbitration"
|
|
depends on GPIOLIB && OF
|
|
help
|
|
If you say yes to this option, support will be included for an
|
|
I2C multimaster arbitration scheme using GPIOs and a challenge &
|
|
response mechanism where masters have to claim the bus by asserting
|
|
a GPIO.
|
|
|
|
This driver can also be built as a module. If so, the module
|
|
will be called i2c-arb-gpio-challenge.
|
|
|
|
config I2C_MUX_GPIO
|
|
tristate "GPIO-based I2C multiplexer"
|
|
depends on GPIOLIB
|
|
help
|
|
If you say yes to this option, support will be included for a
|
|
GPIO based I2C multiplexer. This driver provides access to
|
|
I2C busses connected through a MUX, which is controlled
|
|
through GPIO pins.
|
|
|
|
This driver can also be built as a module. If so, the module
|
|
will be called i2c-mux-gpio.
|
|
|
|
config I2C_MUX_PCA9541
|
|
tristate "NXP PCA9541 I2C Master Selector"
|
|
help
|
|
If you say yes here you get support for the NXP PCA9541
|
|
I2C Master Selector.
|
|
|
|
This driver can also be built as a module. If so, the module
|
|
will be called i2c-mux-pca9541.
|
|
|
|
config I2C_MUX_PCA954x
|
|
tristate "Philips PCA954x I2C Mux/switches"
|
|
depends on GPIOLIB
|
|
help
|
|
If you say yes here you get support for the Philips PCA954x
|
|
I2C mux/switch devices.
|
|
|
|
This driver can also be built as a module. If so, the module
|
|
will be called i2c-mux-pca954x.
|
|
|
|
config I2C_MUX_PINCTRL
|
|
tristate "pinctrl-based I2C multiplexer"
|
|
depends on PINCTRL
|
|
help
|
|
If you say yes to this option, support will be included for an I2C
|
|
multiplexer that uses the pinctrl subsystem, i.e. pin multiplexing.
|
|
This is useful for SoCs whose I2C module's signals can be routed to
|
|
different sets of pins at run-time.
|
|
|
|
This driver can also be built as a module. If so, the module will be
|
|
called pinctrl-i2cmux.
|
|
|
|
endmenu
|
|
|